Jump to content
BookWorm.303

Migrating Windows 10

Recommended Posts

The hard drive I have installed for Windows 10, it's rather small.

I'd like some tips on how to migrate the whole hard drive contents and partition to a new larger hard drive

Share this post


Link to post
Share on other sites

I've used a freebie by the name of AOEMI Backupper from http://www.backup-utility.com/

 

How you go about the whole process can be dependent on how the partitions are setup on the source drive but generally the EFI stuff will be before the OS but there might be a recovery partition after the OS which makes simply extending the OS partition on the new drive a bit more complex.

 

Another freebie to do partitioning stuff I've recently used is MiniTool Partition Wizard from https://www.partitionwizard.com/

I think the free version supports relocating partitions. If there's a recovery partition that follows the OS then you'd want to move it to the end of the drive then extend the OS partition (or just make a second partition to use for data).

 

Generally doing an "intelligent copy" rather than full clone will be quicker, the first type will pay respect to known file systems and only copy data that's in use rather than sector by sector copy of the entire partition which can take a lot longer.

 

Speed in general - if you can use USB 3.0 drive caddies or adaptors or have the drives on Sata2 channels then the whole thing can run a lot quicker.

If you can't give each drive a fast IO channel then put the destination drive on the slowest one.

 

You might get a situation where the dest drive is non-bootable, usually the required fix is to just use command-line tools to mark the main partition as active, keep a bootable Windows USB drive handy for this sort of stuff, it doesn't have to be an installer for the exact version you have, even a Windows 7 x86 installer can be used for such things on a Win10 x64 install.

 

Remember if you're moving to an SSD then you'd want to be running the Sata channel involved in AHCI mode. Usually a simple Bios setting but there's usually pre-requisite work to be done inside Windows so that it boots up properly.

Edited by Rybags

Share this post


Link to post
Share on other sites

Im a fan of offline work on my drives.

 

If I was in your shoes, I'd get a gParted boot CD and load it Live.

 

Then I'd clone the HDD in its entirety, to the new drive.

Then grow the partition.

Mark it as bootable.

Then be done.

 

If you decide to use this tool, be sure to hit 'Go' after you've queued up your steps.

Edited by Master_Scythe

Share this post


Link to post
Share on other sites

If you have bought a new HDD check the manufacturers web site as they sometimes off free versions of commercial cloning software to clone an old drive to a new drive.

Otherwise grab Macrium Reflect Free

https://www.macrium.com/reflectfree

as it can do disk to disk cloning.

Won't work if you have dynamic disk partitions though.

  • Like 1

Share this post


Link to post
Share on other sites

The safest way is to clone original drive to the new drive (don't get it the wrong way round). Some software allows you change partiition sizes during cloning on the target drive

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×